Gallery




Comments

Post a Comment

Popular posts from this blog

Mehndi cone preparation

Mehndi cone preparation Materials required Cellophane sheet/gift wrapping sheet Scissors Nail clipper(optional) Scale/inch tape Cellotape Pins (optional)                                Method Cut cellophane for 7inch length and 5 inch width. Never cut a perfect square.A cone made of perfect square will have it's end near tip and cellotape near tip would come off on mehndi application. Cellotape near tip might smudge design even if it peels of a bit. In 7 inch length mark 2.5 inch,2 inch and 2.5 inch. If you are a right handed person start rolling from right. The cone tip should be on left 2.5 inch mark. Hold your left hand on top tightly and rotate and form cone using your right hand.Use small pin on tip if you want. If you don't want to use pin on tip rotate and form a cone and make sure the tip end is sealed. Using cellotape seal the side.
Read more

Science behind mehndi Stain

Science behind mehndi stain Mehndi powder- A mehndi powder of good lawsone content of atleast 2-3 percent should be used.Though freshness is an important factor ,it is not alone the sole factor determining color of henna. A poor fresh crop can have only Lawsone content. A good quality crop can have very good lawsone content and it if properly stored can be used for years. The lawsone content deteriorates on time. Light and heat can damage the mehndi quality. Keep away from sunlight and if possible refrigerate mehndi powder. Use only dry spoon for using mehndi. Water- Pure water should only be used. Distilled water can also be used. Distilled water reacts when it contacts with air and form carbonic acid as carbon dioxide  dissolves in it.The pH value will be less than 7 and would give good stain. Essential oil- Henna has hennotanic acid which is hydrophobic. So water alone does not help release stain.Essential oil has terps or monoterpene alcohol which helps to release stain....
Read more

How to test henna paste?

How to test paste? A  Henna paste should be like toothpaste. The efficiency of mehndi paste can be tested in three ways. String test Paper test Patch test 1.String test Before filtering the mehndi paste using socks/stocking measure the length of the mehnndi string using inch tape. Mix mehndi paste once using the plastic spoon and vertically lift the spoon with inch tape next to it.The length of the string should be 2.5 inches. If you lift the spoon upwards more than that, the string should break. 2.Paper test This test can be done only after filling the cone. Take a notebook and draw some design. Wait for 10 minutes without disturbing the notebook. After 10 minutes turn the mehndi decorated page and look for these things. The design should be leaked on another side of the paper The traces of design stain should not be seen in next paper/paper below design paper.If stain releases to the paper below it, then you need to reduce the amou...
Read more